Fishing Pole Holder/Mount

This is a remix of Iron_Scorpion Fishing Rod Rack ( https://www.thingiverse.com/thing:3700059 ). I found it difficult to print with the beveled edges all the way around the base. I've cut out the beveled edge so that it will print flat with no supports. Two versions are available: an 11mm wide holder and a beefier 18mm wide holder. I've installed two sets of the 11mm in my attic on angled joists and it works great.

You will need to print 11m A and 11mm B or 18mm A and 18mm B. There are two ends to each set. Each set will hold 4 rigs (rod and reel).