Thingiverse
Fiskars Softouch Scissor Lock
von MJHeed
5
Downloads
4
Likes
0
Makes
Replacement slide lock for Fiskars Softouch Scissors.
No supports.
12 min print time @ 0.2 layer.
__________________________
Update: 2/1/22
The first slide lock worked great for months, but started doing the same thing the original Fiskars slide lock was doing... spreading open too wide, making it too loose.
I created this second "reinforced" version to help limit the spreading and keep it tighter. If you're printing with PLA, I'd use the reinforced version.
12.5 min print time @ 0.2 layer - Minimal supports may be needed on the middle reinforcement rib.
No supports.
12 min print time @ 0.2 layer.
__________________________
Update: 2/1/22
The first slide lock worked great for months, but started doing the same thing the original Fiskars slide lock was doing... spreading open too wide, making it too loose.
I created this second "reinforced" version to help limit the spreading and keep it tighter. If you're printing with PLA, I'd use the reinforced version.
12.5 min print time @ 0.2 layer - Minimal supports may be needed on the middle reinforcement rib.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
