Thingiverse
Fisker Ocean iPhone MagSafe stand
door MrSolu
0
Downloads
0
Likes
0
Makes
**iPhone MagSafe stand for Fisker Ocean**
Tested with an iPhone 17 Pro with a protective case and Apple MagSafe Charger (2 m) (2025).
In portrait mode, it is possible to use Hollywood Mode, but not in landscape mode. The phone is angled so that the driver is more or less centered in the phone’s camera view. This makes it possible to have video meetings or calls.
I printed it in ASA, but use whatever material you think is best for you. UV resistance is recommended.
Support is needed.
The complete one has a build size of 292 x 2711 x 87mm.
If your printer doesn’t have a large enough build area, you can use the half-size version instead. In that case, it’s recommended to add some double-sided tape on top to make sure it doesn’t fall off.
The build size for the half version is 158 x 162 x 45mm.
When printing, place the MagSafe side against the print bed.
Tested with an iPhone 17 Pro with a protective case and Apple MagSafe Charger (2 m) (2025).
In portrait mode, it is possible to use Hollywood Mode, but not in landscape mode. The phone is angled so that the driver is more or less centered in the phone’s camera view. This makes it possible to have video meetings or calls.
I printed it in ASA, but use whatever material you think is best for you. UV resistance is recommended.
Support is needed.
The complete one has a build size of 292 x 2711 x 87mm.
If your printer doesn’t have a large enough build area, you can use the half-size version instead. In that case, it’s recommended to add some double-sided tape on top to make sure it doesn’t fall off.
The build size for the half version is 158 x 162 x 45mm.
When printing, place the MagSafe side against the print bed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
