Thingiverse
Fitbit / Watch Stand
von Bixler13
15
Downloads
13
Likes
0
Makes
Print two rod holders and don't forget to MIRROR one!
Print WITH supports for the ends of the butterfly wings.
The rods are 5/16in in diameter. Cut the rods to length and use a hammer to press them into the holes. No glue should be required.
Printed on Printrbot simple
.25mm layer thickness
15% infill
If you want a two tone effect just pause the print and switch your filament.
Print WITH supports for the ends of the butterfly wings.
The rods are 5/16in in diameter. Cut the rods to length and use a hammer to press them into the holes. No glue should be required.
Printed on Printrbot simple
.25mm layer thickness
15% infill
If you want a two tone effect just pause the print and switch your filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!