Fix for broken rubber holder

I printed 3 launchers , and all of them quickly had that issue ..;
This will save your intiial print and only takes 7 minutes to print

It's not a remix ,
Its a fix to print when the bottom part ( that holds the rubber in place ) is broken

I quickly did it directly from my Slicer ( Prusa )
It should be ok to have 2 rubbers in the same time ( the tip is to strech them enough to make them thin in the enclosure and put the piece in place )

Version 2 : I added two "pin" to make the piece more secure and block in its place.


Drawback : I lost the automatic locking of the launcher .. If someone can change my piece to get it back , my son will be happy. :)