Thingiverse
(fixed bottom layer) Crown sphere holder
von Only1YeastyBeast
0
Downloads
0
Likes
0
Makes
I was having issues with the bottom layer sticking so the inner circle is extruded .4mm down to make a solid 1st layer.
this crown has roughly a .25 inside diameter to start instead of being as big as my build plate
this crown has roughly a .25 inside diameter to start instead of being as big as my build plate
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
