Fixture Table TIG Torch Holder

This is a holder for a 17 series TIG torch that should attach to most fixture tables that use a 5/8" hole on 2" centers arrangement. It was designed to fit Primeweld's 2'x3' fixture table, and it should also easily fit Langmuir System's 2'x3' fixture table, but really any table with 5/8" on 2" centers or probably 16mm on 2" centers as well. When you look at the model, you will see that the top of the holder has a pair of 5/8" pins to register in the table holes, and the printed pins (two needed) will snap into the table's side face locking the holder in place. It is a VERY tight fit. Print it out of something strong that will hold up to a tap or two from the rubber mallet to install. Print it out of something that will hold up to the heat of a hot TIG torch. I used Bambu's ASA-CF and I couldn't be happier. I've dropped my torch in the holder after welding thick aluminum, and seen zero signs of melting. If you can't dow