Flag for a soda straw

Remixed from: https://www.thingiverse.com/thing:2051483

I help out with our local high school robotics team. We have a Minibot competition every December. We needed flags that we could place/remove from the minibots to identify which alliance they belong to. I came up with these.
The bottom of the pole should fit in a common soda straw. You might need to fiddle a bit with the scale to make it fit.
Print in PLA with low (e.g. 20%) infill. Print with the tip of the flag pointed up. Make sure your initial layer adhesion is good!