Thingiverse
Flag Pole Swivel Mount
by PPGPrinter
49
Downloads
44
Likes
1
Makes
Flag Pole Swivel Mount for 25mm diameter Flag Pole.
Designed a replacement for the one that came with the flagpole that broke. Reused the original Thumb Screw hardware. Thumb Screw matches the small bolt pictured - Diameter was just under 6mm and the pitch was 1mm.
Thread test print included if you want to check the threads before printing the whole thing.
Parts to print are the Sleeve, Collar and Swivel. I printed the Collar upside down & used supports for the threads - may not need it - a little hard to get out of the thread area but the threads worked great after getting it cleared.
Thumb screw works better than a bolt to provide clearance for the swiveling carabiner.
Thumb Screw like https://www.amazon.com/s?k=014973323936
Small Carabiners like https://www.amazon.com/gp/product/B07VS4WJ69/
Designed a replacement for the one that came with the flagpole that broke. Reused the original Thumb Screw hardware. Thumb Screw matches the small bolt pictured - Diameter was just under 6mm and the pitch was 1mm.
Thread test print included if you want to check the threads before printing the whole thing.
Parts to print are the Sleeve, Collar and Swivel. I printed the Collar upside down & used supports for the threads - may not need it - a little hard to get out of the thread area but the threads worked great after getting it cleared.
Thumb screw works better than a bolt to provide clearance for the swiveling carabiner.
Thumb Screw like https://www.amazon.com/s?k=014973323936
Small Carabiners like https://www.amazon.com/gp/product/B07VS4WJ69/
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!