Flame Dragon Repair

I have done a few more repairs than other remixes that I have found.

* Geometry of the legs - merged them properly with the segments they are attached to and removed the excess that was intersecting with other segments
* Adjusted the spacing between the segments that were fusing during print
* Lengthened the tail piece at the joint as it was fusing to the final segment due to it's height
* Removed some unnecessary geometry from most segments and corrected some normals

The last few segments will still need a little force to get moving, but I did what I could with the limited space.

I printed using .2mm first layer and .16mm for every other layer.