Flame Fist - Ergonomic

Thanks to Pinky Ponky Design for the original model. I made this remix for increased comfort, and to allow your fingers to come closer together, so it's easier to keep hold of whatever you're smoking.I also made the finger holes slightly larger, as the original was a bit tricky to take off. Apparrently I have chunky fingers 🤷🏻 🤣Due to less surface area touching the print bed, I recommend printing this version with a brim and with supports for the bottom arch (included in print profile).A little clean up will be needed on the bottom, to remove sharp edges and the rough arches. A few backwards scrapes with a sharp knife, and a quick rub with some sand paper, will make it feel much nicer in the hand.I have included the .step file so that it's easier for anyone to edit, but be warned, it's an absolute sh*t show in there, due to starting with an .stl file.EDIT: I have also made a single ring version: https://makerworld.com/en/models/417314#profileId-319684CAUTION: It seem