Thingiverse
Flash Forge Creator Pro Filament Guide 2016 Hex Bottom
43
Downloads
23
Likes
1
Makes
After I noticed my original spool holder had cracked and miraculously still holding on, I went back to the drawing board!
In this new design I shortened the height, overlapping the weak spot and helping in printing. The first design used a lot of support and I have a hard time printing curved bottoms due to the overhang. Now that it prints flat to the bed then angles up the print is stronger and prints faster!
In this new design I shortened the height, overlapping the weak spot and helping in printing. The first design used a lot of support and I have a hard time printing curved bottoms due to the overhang. Now that it prints flat to the bed then angles up the print is stronger and prints faster!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
