Flash Forge Creator Pro Filament Offset Guide

This is a filament feed offset for the Flashforge Creator Pro. The Creator Pro normal attachment point for the filament feed is too close to the body of the printer. Without this offset, the filament can slip between the spool and the body of the printer and get stuck. Not good. This offset clips securely into the built into Creator Pro body and moves the filament 20cm further away from the body. Relocated to the middle of the spool, this filament guide prevents any jamming or misalignment of the filament.

This is designed with holes large enough to easily accommodate 1.75 mm filament. I've printed this successfully already and it turned out perfect on the first try. Be sure to print with the bottom down so as to not need any support material.