Thingiverse
Flash hider with fast removing Supressor
by Brettje
16
Downloads
18
Likes
0
Makes
hi,
i made this to fit the replica in my gun case. this to avoid buying a new gun case. this thing is still in progress but i still wanted to show you guys my design. i hope you like this! (improvements may take place over time).
the whole print took about 5 hours. 1 hour for the flashhider and supressor cap, and 4 hours for the supressor tube. you can fit some foam or scotchbrite on the inside to soften the aeg's sound. after that you can glue the top cap in place.
the 14mm ccw test file is added so you dont have to print the whole flash hider.
Note: You need an o-ring for a perfect fit. (see the picture)
greats Brett.
Update:
19-07-2020 sup tube(V2).stl added: the bottom section is smoothened to prevent the oring from damaging.
i made this to fit the replica in my gun case. this to avoid buying a new gun case. this thing is still in progress but i still wanted to show you guys my design. i hope you like this! (improvements may take place over time).
the whole print took about 5 hours. 1 hour for the flashhider and supressor cap, and 4 hours for the supressor tube. you can fit some foam or scotchbrite on the inside to soften the aeg's sound. after that you can glue the top cap in place.
the 14mm ccw test file is added so you dont have to print the whole flash hider.
Note: You need an o-ring for a perfect fit. (see the picture)
greats Brett.
Update:
19-07-2020 sup tube(V2).stl added: the bottom section is smoothened to prevent the oring from damaging.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
