Flash Light

This is a simple flash light. All you need is a 3D printer, soldering iron, pliers, two AA batteries, a 10mm LED, piece of wire and shrinkwrap or electrical tape. This design is based around a 10mm white super bright led: https://www.sparkfun.com/products/11118. This design doesn't need a resistor as it only draws about 3/4 of its max current when hooked up to the batteries. If you plan to use a different LED measure the current draw. If you have any questions about assembly please ask.
I will post a design based around 4 5mm LED's next. Be patient.
Enjoy!