Thingiverse

FlashForge 5M Pro Small Spool Holder

di RJP-Retired

2 Download

2 Likes

0 Makes

When I set up my new FlashForge 5M Pro, I was, once again, faced with the problem of small diameter filament spools. While the 5M is better at supporting non-FlashForge spools than my old Adventure 3, it still would not support the smaller diameter Sunlu 250gm spools I use often. I looked for one on Thingiverse. No luck, so I cobbled together this one. It works well. I suppose it will fit a plain FlashForge 5M, but I don’t have one.

Printer: FlashForge 5M Pro
Filament: PET-G
Supports: Yes (for the spool end keeper)