FlashForge AD5X Enclosure Modifications

I've uploaded these here as there appeared to be interest on a Reddit thread but note that this is a work in progress. The main guides and parts were all printed in Yellow Elegoo PETG Rapid and the rise blocks in JAYO PLA+ Grey as I ran out of the yellow and I am still deciding what to do with the 60mm panel gap*.I didn't like the printed model number on the front plate, so initially removed it completely and then slimmed the part down - see photo. The stub is held in place when the guide upright screw is tightened. The top enclosure wasn't high enough and the Bowden tubes from the IFS were rubbing against the top rim and the panel. I have cut and shunt created 60mm riser blocks to avoid reprinting the top riser supports.* The panels now have 60mm gaps and I intend to create fillers but am looking at a complete redesign of the IFS side panel and may incorporate the fillers into the riser blocks.For me, the enclosure kit isn't fit for the purpose (I had hole alignment is