Flashforge Adventurer 5M Pro Lid Riser

I've remixed this from the original one-piece model I found and sectioned into 4 pieces, 2 pieces per plate, this lid riser for the Flashforge Adventurer 5M Pro. Without the riser, the filament tube rubs on the clear plastic lid. I had printed the existing adaptation I found on Cult3D, as well as the 4 piece design by the original designer, both left me wanting a little more.

This piece sits down in the recessed opening on top of the 5M Pro, and the lid fits into this (the same as with the other models). I found the other remix on here to be too tight side to side, I literally had to shave the recessed portion of it to fit down into my printer. I also wasn't satisfied with the dowel pin assembly. While it was too tight for me side to side, it was extremely loose front to back, and the recessed portion of the lid riser did not set down on the 5M Pro's gasket.

I remixed making it taller to where this riser sets simultaneously on the gasket and the top of the printer