Thingiverse
FlashForge Creator Pro 2016 Feet
por Seamongrel
56
Descargas
25
Likes
1
Makes
I just got my new FlashForge Creator Pro2016 printer and I've already started on mods for the printer.
The first was to design some feet for the printer for three reasons, firstly to lift the printer up so I could install a fan system under the main board of the printer for extra cooling.
The second reason was to have the ability to level the printer by screwing the bottom part of the foot in or out of the printed foot housing.
The last reason was for the felt pads on the bottom of the feet, making the printer much easier to turn around on the table.
You'll need 4 5/16 x 5/8 bolts and 4 5/16 nuts. I used imperial because I had them lying around from the feet I printed for my Mankati XT. You could use M8x16mm bolts as they would fit as well.
I've also included a foot with a glue holder or you can just print 4 of the other foot.
The first was to design some feet for the printer for three reasons, firstly to lift the printer up so I could install a fan system under the main board of the printer for extra cooling.
The second reason was to have the ability to level the printer by screwing the bottom part of the foot in or out of the printed foot housing.
The last reason was for the felt pads on the bottom of the feet, making the printer much easier to turn around on the table.
You'll need 4 5/16 x 5/8 bolts and 4 5/16 nuts. I used imperial because I had them lying around from the feet I printed for my Mankati XT. You could use M8x16mm bolts as they would fit as well.
I've also included a foot with a glue holder or you can just print 4 of the other foot.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
