Thingiverse
Flashforge Creator Pro Dome hinge
door mrmadjack
26
Downloads
15
Likes
0
Makes
Hello,
This is a Hinge for the dome of the Creator Pro, i was tired of moving the thing around so i designed a hinge.
It needs the blocks to support the weight of the dome, couldnt get around that one.
Used some double sided tape to stick them to the printer.
You will have to drill some holes throught the plastic dome (be gentle as the plastic tends to crack) and maybe dremel/saw off the corners of the rear most panel of the dome.
I used M3(metric) screws for everthing.
The hinge is printed at 50% infill at 0.2 layerheight.
The blocks at 10% and 0.2 layerheight
This is a Hinge for the dome of the Creator Pro, i was tired of moving the thing around so i designed a hinge.
It needs the blocks to support the weight of the dome, couldnt get around that one.
Used some double sided tape to stick them to the printer.
You will have to drill some holes throught the plastic dome (be gentle as the plastic tends to crack) and maybe dremel/saw off the corners of the rear most panel of the dome.
I used M3(metric) screws for everthing.
The hinge is printed at 50% infill at 0.2 layerheight.
The blocks at 10% and 0.2 layerheight
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!