Flashforge Creator Pro Magnetic Door Latch

I was tired of cracking my door (you can see the crack in the picture) because I would forget to unlatch the holder I printed off a while ago as one of the first accessories for my printer.

So I designed up this simple magnetic door latch. It uses 2 Neodymium 1/2 x 1/8 inch Disc N48 Magnets. One super glued to the door, and the other hot glued into the holder.

1) Remove the center screw (2.5mm hex) from the front frame of the FFCP Printer.
2) Insert screw into holder and screw all the way down. Its supposed to be tight.
3) Screw the holder back into the printer, and position the holder facing downward, and tighten down the screw.
4) Using the holder to turn (do not use the screw), unscrew the holder.
5) Hot glue the magnet into the holder (keep the other magnet attached to this one)
6) Once cooled, again using the holder, screw it back into the printer. It should be nice and tight, facing downward.
7) Place a small drop of super glue on the other magnet and open the door a