FlashForge Creator Pro top plate

This Thing offers both a replica of the top plate of the 2016 FlashForge Creator Pro (unsure whether this is different on older models), and an improved version (‘v2’ suffix). This is the part that connects the umbilical cord and the filament guide tubes to the carriage.

Unless for some reason you need the exact same part as the original, I recommend printing the v2 model. It uses less material hence is lighter, and has beveled holes that make it easier to insert the filament guide tubes. It also has a rounded front edge that reduces stress on the fan cables (and looks nicer!)

Of each model, two variations are included: one with normal round holes, and one with polyholes that should give a better chance at properly dimensioned holes without post-processing.

This part does not have very stringent requirements when it comes to structural integrity, only the center part around the holes is important. Its only task is to hold the umbilical and filament guide tubes in place. Use at