Flashforge Dreamer Cable Harness Guide

Although I’m really satisfied with my Flashforge Dreamer, I have been annoyed about how the cable harness to the heated head drops down to rest on the rubber belt in certain positions.....so I decided to design a swinging arm to support and guide the harness away from the belt.
It is made up of 3 printed parts, a cable tie and a PTFE Teflon tube, cut into small sections to give a roller effect to allow the cable harness to move through it as the head moves around inside the enclosure.

Parts required to build this part:-
ABS Filament.
PTFE Teflon Tube 3mm I/d...4mm o/d.
Nylon Cable Tie....100mm long, 2.5mm wide