Thingiverse
FlashForge Finder External PLA Adaptor
by rengolin
16
Downloads
10
Likes
1
Makes
Simple adaptor to have external PLA filaments coming through the side. It works better if the drum is very close to the printer and it spins without wobble.
The drum in the picture has another adaptor that fits the small size of the spindle with the large size of the drum hole. Before, it used to tangle if I let it loose.
The reel adaptor works even when printing low res. Since it's going to be hidden mostly, it's not an issue. Also, using rubber bands to keep the reel in place is recommended.
Update: slight reduction on the hole to hold the conduit in its place.
The drum in the picture has another adaptor that fits the small size of the spindle with the large size of the drum hole. Before, it used to tangle if I let it loose.
The reel adaptor works even when printing low res. Since it's going to be hidden mostly, it's not an issue. Also, using rubber bands to keep the reel in place is recommended.
Update: slight reduction on the hole to hold the conduit in its place.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
