Thingiverse
Flashforge Finder Spool Holder
door m1s2h3
386
Downloads
314
Likes
16
Makes
A spool holder that hangs on the side of the Flashforge Finder 3D printer.
PLEASE READ ALL INSTRUCTIONS
You will need to print out the Spool Hook as well as the Guide Tube Holder then you have the choice of two different sizes of the Spool Roll rod.
If you have any questions on assembly or improvements please let me know.
Note: The Flashforge Finder branded filaments will fit on this spool holder but you will have to take the spool rod out first because the spool wont fit over the lip on the end.
PLEASE READ ALL INSTRUCTIONS
You will need to print out the Spool Hook as well as the Guide Tube Holder then you have the choice of two different sizes of the Spool Roll rod.
If you have any questions on assembly or improvements please let me know.
Note: The Flashforge Finder branded filaments will fit on this spool holder but you will have to take the spool rod out first because the spool wont fit over the lip on the end.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
