Thingiverse
FlashForge Spool Holder Cover
von cpayne3d
3
Downloads
1
Likes
0
Makes
FlashForge Spool holder mount cover plate.
license: Creative Commons - Share alike - Attribution - Non-Commercial
This is a simple cover to plug the spool holder mount holes in the back side of the Flashforge Creator Pro, when you are not using the spool holders. This keeps the outside air from affecting your prints.
The OpenScad file is included for your use. Modify if you wish.
Not for commercial uses.
license: Creative Commons - Share alike - Attribution - Non-Commercial
This is a simple cover to plug the spool holder mount holes in the back side of the Flashforge Creator Pro, when you are not using the spool holders. This keeps the outside air from affecting your prints.
The OpenScad file is included for your use. Modify if you wish.
Not for commercial uses.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
