Flashlight barrel mount
von Hassehopp
4
Downloads
7
Likes
0
Makes
Simple to print without support.
There will be stringing but just remove it.
I lost my oridinary mount so i created one of my own.
It fits perfectly with my Ledlenser flashlights on both .308win and .338winmag barrel
Barrelhole 16mm
Flashlighthole 25mm
(Use flexible filament, not PLA or ABS !)
I used
TPU 90A
Speed 30mm/s
Infill 25% (more fore harder)
Print temp 220C
Build plate 50C
No Retraction
No Support
Brim 8mm
Added a V2
If you print V2 add more infill or use a harder flexible filament
Please "post a make" and share picture if you make one :-)
There will be stringing but just remove it.
I lost my oridinary mount so i created one of my own.
It fits perfectly with my Ledlenser flashlights on both .308win and .338winmag barrel
Barrelhole 16mm
Flashlighthole 25mm
(Use flexible filament, not PLA or ABS !)
I used
TPU 90A
Speed 30mm/s
Infill 25% (more fore harder)
Print temp 220C
Build plate 50C
No Retraction
No Support
Brim 8mm
Added a V2
If you print V2 add more infill or use a harder flexible filament
Please "post a make" and share picture if you make one :-)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
