Flashlight Stand / Holder / Wallmount

UPDATE !!!!
I was looking for a holder for my Sofirn SP32a flashlight where you don't have to push the lamp in. Where you don't have to exert any force to break the plastic.Here is the Solution. Not small, but usable.

There are two holes to mount the holder on the wall.

Things to print:

1x Stand :
V1 - small - 3cm
V2 - tall 6cm
1x middle Bumper
1x lower bumper
V1 - plain version
V2 - small extrusion in the middle to hold the flashlight centered
V3 - plain version with mount for a small magnet(6x2mm) on the downside
V4 - plain version with mount for a bigger magnet(25x3,5mm) on the downside



You have to print the bumpers with TPU or another flexible material. The pink bumpers are printed with REC Flex Pink. The violet bumpers are printed with Filament PM - RubberJet TPE88 – metallic violett from the german store schmelz.bar
The black parts are printed with ASA / Apollox from FormFutura, but you can use any other material.

Update:
17.02.2020: change Low