Thingiverse
Flat fabric (3mm)
von jbergmans
3.1k
Downloads
2.5k
Likes
15
Makes
+ Only 3mm thick.
+ Flat on both sides.
+ Stretchable by design.
+ Easily repairable.
After printing the fabric, it might feel a little bit "stiff". Go through the fabric row by row and rotate each row forth and back until it moves smoothly. Do the same thing for the columns. This entire operation should take no longer than a few minutes. After doing this, the fabric should be smooth and flexible.
https://youtu.be/fbI_SA-pelc
+ Flat on both sides.
+ Stretchable by design.
+ Easily repairable.
After printing the fabric, it might feel a little bit "stiff". Go through the fabric row by row and rotate each row forth and back until it moves smoothly. Do the same thing for the columns. This entire operation should take no longer than a few minutes. After doing this, the fabric should be smooth and flexible.
https://youtu.be/fbI_SA-pelc
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
