Thingiverse
Flat Pixel Inserter
von gsims
2
Downloads
0
Likes
0
Makes
Insert tool and mesh holder for inserting flat pixel nodes into 2" mesh.
Put mesh holder on front side of mesh. It can be laid on a flat surface if desired.
To use the insert tool.
Place the back side of LED Node in the inserter with the ears in the slots.
Note:the wires do not go into the slots.
While holding the mesh tool Press the LED Node and the inserter into the hole in the mesh. It may take little force and twist.
Put mesh holder on front side of mesh. It can be laid on a flat surface if desired.
To use the insert tool.
Place the back side of LED Node in the inserter with the ears in the slots.
Note:the wires do not go into the slots.
While holding the mesh tool Press the LED Node and the inserter into the hole in the mesh. It may take little force and twist.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
