Flat sided WTD 3.5

This was a very simple lure to model, and will probably swim the best. Life is funny that way. It's a topwater and sit tail down. Use double hooks if you have it or else use treble.

Pause at layer 67 in order to add your weight; amount of weight is unknown. I would start off with a few grams but really depend on your hardware weight.

Model volume is 31.03g/cm^3
weight of filament is ROUGHLY 15.25g IF printed at 4walls and 5%infill. I use Overture PLA
In order to float, your total weight should be well below 31gram.



https://www.youtube.com/shorts/PbeasDthBJk