Fletching jig - remix

This is a modification of the https://www.thingiverse.com/thing:578962 fletching jig.
(The ID did not show up in the search list when I selected remix, not sure why.)

I beefed up the ears on the base and increased the thickness of the arm section where it interacts with the base. This should prevent any tweaking of the ears if the screws are tightened a little too much.

I also tweaked the clearance on the base for the arms, so it should not be as tight, I had to sand the arms slightly when I printed the original, this should require less fitting.......

I also found that scaling the V2 clamp clamp to 101% made a better fit (not as tight / should not bind), this may also differ depending on the print material used.

And lastly, I found that applying wax to the arm grooves seems to prevent any excess glue from adhering to the PLA (if that is what you print with), at least so far...

Edit: made a tweak to the arm, The hole size was not optimal, this should be a better (tigh