FLEXATX Power Supply Case

This is a project case for a FlexATX power supply. I have a ton of them harvested from dead servers (common power supply in small 1RU servers) and needed a way to mount one up to power some LED lighting.

The case is in 3 parts, I call the AC side (AC Plug), center section and DC Side. Has holes for a power switch, second fan and the output leads. There is enough room for a small amount of electronics in the DC side if you wanted to (maybe a constant current circuit for instance.)

I never actually bothered to print the center section. The fit is pretty snug, with only a tolerance of about .25mm here and there. The center section is deliberately undersized about .5mm lengthwise (rather have a little slop than too tight.)

If you use the second fan, mount it first and reach through the blades to mount the DC side to the power supply.