Flexi Articulated Tie

I made my own version of the Flexi Articulated Tie

Use 1.75mm FIlament to "link" the parts together. if you have a hard time sliding it in (it should be a snug fit) use your knippers. to GENTLY grib a few mm from the edge and PUSH it will slide right in with the knippers.

snip off excess

I included 3 extra "knots" one with the Home symbol one with the luck cat symbol and one "blank" so you can imprint whatever you want. sink it .6mm in for a nice effect and use at least 4 top layers.

I print this at 0.3mm layers but after 7mm I switch to 0.2mm for a clean "knot top" I used a 0.6mm nozzle but 0.4mm would work fine.

I left the top and bottom layers off for that neat "infill" look. this is why the tie is separated into 3 chunks instead of one with all 3 pieces. infill is determined by the entire platter. not per part. so the infill won't "center" properly unless you process each chunk separately. in s3d I do this with multi process so the infill is separately calculated for