Flexible Display Stand and Hangers

Updated Display Stand/Hangers as related to Dragons with a few improvements/changes. Significantly larger capacity but still printable on Bambu P1x, XIC or A1. Consolidated the medium and large dragon stands into a single model. Previous large dragon model could hold approximately 8 full size dragons, this model will hold approx. 14 depending on how you hang them (see pictures) Previous medium dragon model could hold approximately 16 medium dragons if you really stacked them in there, this model will hold approx. 20-22 depending on how you stack them. Slightly tighter tolerances on the rods to improve stiffness. Can use both hangers for Large Dragons (100%) or can use 1 hanger for Large Dragons and 1 hanger for Medium Dragons on the same stand. Includes a top mounted sign holder with set screw. Space is 4mm so you can use 2 x 2mm signs . Update: 9/3/2024 Added keychain hangers Added earring hangers (can be mounted as single, or double by printing both bottom (default) and top. Added 120mm Rod (rods can be whatever length you want in Bambu Studio) Changed model name to Flexible Display Stand & Hangers As with all the hangers, they can be mixed and matched on the same stand, or different stands can be printed for each type of hanger.   Note: The v1 base, rods, connectors will fit this if you've already printed them and just want to use the new hangers though they might be a smidge loose so use a piece of electrical tape or masking tape on the end of the original models rods if you find them too loose.   To achieve the larger sizes, the hangers were broken into 3 parts, the hanger center and the hanger (left and right are identical). There are both large and medium dragon hangers that can be mixed and matched if desired. They connect with 4 dowels that print on the hanger and mate to 4 holes in the hanger center.    Note: These hanger components are a very tight snap/press fit, they can be removed with a screwdriver or other tool but are not intended to be plugged in,