FlexMount Jersey Hanger V2

V2 has been uploaded. This hook gives more of a natural curve and eliminates the sharp corner V1 had. I initially wanted to design a small hook that attaches to the track of my ceiling tile so I could hang a standard clothing hanger to display my jerseys, but I got a bit carried away. I figured a full hanger system would look cleaner and be more efficient. With this setup, the arms of the jersey can flair out a bit to show off just a liiiittle bit more. There are two hook styles: one that slides onto a ceiling tile track, and one that can be screwed into a wall. The wall hook needs to be installed upside down (with the “square” on top) so the hanger hides the screws. The ceiling hook should be printed on its side with supports to give it max strength and reduce the risk of snapping. No glue required. The pieces slide together, and the jersey helps hold everything in place. I used PLA for the test run and it feels solid. Once the jersey is on, there’s not much movement, so stress on the