Thingiverse
Flight Controller softmount
door DiAleksi
14
Downloads
13
Likes
0
Makes
Softmount for quad's flight controller.
3mm hole for mounting to frame screw and plug to fit and lock in to fc's 3mm holes.
The distance between upper and bottom part is around 6-7 mm.
You can stick plugs from below or from above.
Print with semiflexible tpu. There is two version soft and hard. The hard version is suitable for most semiflexs. But if you have too stiff tpu, use the soft version.
3mm hole for mounting to frame screw and plug to fit and lock in to fc's 3mm holes.
The distance between upper and bottom part is around 6-7 mm.
You can stick plugs from below or from above.
Print with semiflexible tpu. There is two version soft and hard. The hard version is suitable for most semiflexs. But if you have too stiff tpu, use the soft version.
DiAleksi publiceert ook op
26 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
