Flight-Shaft-System (V1.2)

EN: New version of my previous model. I changed the angles of the flight so its more accurate to the original flight. This shaft-flight-system is modeled on that of the Target SYNC Swiss Point 01 (see pictures). The thread used is BA2 and can be screwed perfectly. I highly recommend printing with TPU due to its strength. Otherwise it can happen that the rear part of the shaft-flight-shaft system breaks off on the thread. In this case, I recommend heating a thin screwdriver or similar with a lighter and carefully unscrewing the thread. If the support material causes an unclean surface on the upper part of the flight, it can be refinished with fine sandpaper. If you like the model, feel free to follow me. In the future I will create and upload other flights and the like. DE: Neue Version meines vorherigen Models. Ich habe die Winkel des Flights angepasst, sodass er mehr dem Original ähnelt. Dieses Schaft-Flight-System ist dem des Target SYNC Swiss Point 01 nachempfunden (siehe Bilder). D