Thingiverse
Flik Wing camera mount
di dpedu
3
Download
6
Likes
1
Makes
Camera mount for the ThinkFlight/RCTESTFLIGHT Flik wing kit. Designed to fit the Caddx Ant, but should fit anything with similar dimensions.
Print two of the "arm" and "anchor" pieces, and one of the "main" pieces.
Requires two M2x6 screws and two M2 x 2mm heat set inserts.
Scaling: the long dimension on the "main" piece is 46mm.
The two "anchor" pieces are to be glued into the airframe. The two "arm" pieces are to be glued into the "main" piece. Then, the main assembly can be screwed into the anchor installed in the airframe.
Alternatively: for a permanent but simpler installation, omit the hardware and "anchor" pieces and simply glue the main assembly into the airframe, with camera already installed.
Print two of the "arm" and "anchor" pieces, and one of the "main" pieces.
Requires two M2x6 screws and two M2 x 2mm heat set inserts.
Scaling: the long dimension on the "main" piece is 46mm.
The two "anchor" pieces are to be glued into the airframe. The two "arm" pieces are to be glued into the "main" piece. Then, the main assembly can be screwed into the anchor installed in the airframe.
Alternatively: for a permanent but simpler installation, omit the hardware and "anchor" pieces and simply glue the main assembly into the airframe, with camera already installed.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
