Thingiverse
Flip open pencil case
door Badadz
30
Downloads
38
Likes
0
Makes
Similar design to the old wooden pencil cases where the case pivots open and close and a sliding lid to lock it all in place. Nowadays this is more useful for pens. I imagine its multi-purpose too - I am thinking about putting my 3d bits and pieces in this.
All pieces = No Support Needed
Infill 10% but with "Wall Line Count = 4" recommended so the bolt hole is strong (Its the only advanced setting to change in cura)
Only need 1 x M5 bolt to lock it together (M5 x 30mm) with optional nut.
(I actually only used a M5x24 and because it screws in firmly and taps itself as you screw in, no nut needed)
All pieces = No Support Needed
Infill 10% but with "Wall Line Count = 4" recommended so the bolt hole is strong (Its the only advanced setting to change in cura)
Only need 1 x M5 bolt to lock it together (M5 x 30mm) with optional nut.
(I actually only used a M5x24 and because it screws in firmly and taps itself as you screw in, no nut needed)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
