Thingiverse
Flip32+ V5 case (bottom)
von robs113
4
Downloads
3
Likes
0
Makes
This is a case for the new V5 form factor Flip32+.
The holes are 3mm, I just tapped them and use small screens to secure the board.
As the board is quite protected in my quad I decided there was no need for a top cover.
The holes are 3mm, I just tapped them and use small screens to secure the board.
As the board is quite protected in my quad I decided there was no need for a top cover.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
