Thingiverse
FLIRC vixen baseplate
von amendolajamie
9
Downloads
6
Likes
0
Makes
Vixen baseplate for FLIRC Raspberry PI 4 case. You'll need a metric screw to go along with it.
Added camera tripod threads for using a camera on a tripod, like the fisheye setup shown.
I cut some 1/4 thread about an inch or two long, screwed them into the base using locktite. Also used a long 1/4 nut for mounting to the tripod. So this is much like US cars now, and conveniently supports both metric and imperial! :P
OH, and for the latest version I switched everything to imperial threads. They're cheaper here:P
Added camera tripod threads for using a camera on a tripod, like the fisheye setup shown.
I cut some 1/4 thread about an inch or two long, screwed them into the base using locktite. Also used a long 1/4 nut for mounting to the tripod. So this is much like US cars now, and conveniently supports both metric and imperial! :P
OH, and for the latest version I switched everything to imperial threads. They're cheaper here:P
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
