Thingiverse
Flite Test Bushwacker Wheels 100mm
por cjspecial1
53
Descargas
39
Likes
0
Makes
I created several styles of wheels for the FT Bushwacker. These simply snap together and slide on the Axle Wire. I recommend gluing the halves together with either CA glue and kicker or with hot glue. I plan on adding a couple rubber bands for traction or even a strip of an old inner tube...
Happy Printing!
Print with 3 perimeters and 3 layers @ 100% infill.
They are setup to print as a pair on a 200mmx200mm print bed to save time.
Single Wheels will fit most printers, print qty 4 for a full set.
Update 1/27/18: Added TPU Tires. Two versions; Slick and Grooved. No glue required, just strech over the wheels.
Update 1/28/18 Created a tire with more of a radius on the tread. Should provide better tracking on the ground. It will bring the overall diameter to 108mm.
Happy Printing!
Print with 3 perimeters and 3 layers @ 100% infill.
They are setup to print as a pair on a 200mmx200mm print bed to save time.
Single Wheels will fit most printers, print qty 4 for a full set.
Update 1/27/18: Added TPU Tires. Two versions; Slick and Grooved. No glue required, just strech over the wheels.
Update 1/28/18 Created a tire with more of a radius on the tread. Should provide better tracking on the ground. It will bring the overall diameter to 108mm.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!