Thingiverse
Flite Test Tutor Hood
by SARGEx117
4
Downloads
1
Likes
0
Makes
Battery cover replacement for the Flite Test Tutor.
Mine fell off mid-flight and I figured I would just design a cool one instead of a simple foam replacement.
Offers 6 spots for 5x2mm round magnets, as well as 3mm skewer holes to keep it in place.
The separate air scoop piece glues down inside the hood in a retaining ring, to allow for air to be directed down to cool the electronics more directly.
If your printer supports are easily removable then it shouldn't be a problem, otherwise you may need good cooling for bridges.A little play is okay where the scoops glue in.
Mine fell off mid-flight and I figured I would just design a cool one instead of a simple foam replacement.
Offers 6 spots for 5x2mm round magnets, as well as 3mm skewer holes to keep it in place.
The separate air scoop piece glues down inside the hood in a retaining ring, to allow for air to be directed down to cool the electronics more directly.
If your printer supports are easily removable then it shouldn't be a problem, otherwise you may need good cooling for bridges.A little play is okay where the scoops glue in.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
