Slicer Discord
Floatant Caddy – Modèle 3D imprimable de MakerWorld MakerWorld
Sport & Outdoors

Floatant Caddy

96 Téléchargements
36 Likes
54 Makes
Voir le modèle
When fishing dry flies, it's useful to have both a powder desiccant (Shimazaki Dry Shake, Loon Top Ride, etc) and a liquid floatant ( Gink, Aquel, etc). Rather than fish them out of pockets, this caddy holds both and clips on to a vest or pack loop. This caddy was designed to fit loon's top ride and aquel floatant, shown below with a short piece of elastic cord and a small carabiner.Knot one side of the cord and pass thru the back of the caddy. Loop around the front and pass thru the second hole and knot.It should fit snuggly below the cap of the Top Ride.After making sure your Top Ride is capped tightly, flip the caddy over and insert the Aquel with its cap off.Then tighten the Aquel cap.Insert the small carabiner (or other attachment: cord, snap swivel, etc) thru the top hole and attach to your vest or pack.
Catégorie
Sport & Outdoors
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection