Thingiverse
Floater cover
por ChrisPV
3
Descargas
0
Likes
0
Makes
this cover belongs to the floater- the watertight 3inch cinewhoop . https://www.thingiverse.com/thing:4123584?fbclid=IwAR1wbpeKVfSESwlXnMQSOANH1BBULAYvEqDszmIkcRzCAlYjgLBoGh4GwRo
didn't like the sealing and the cover of the original file, so i had to come up with my own idea,
For the sealing i take a peace of TPE filament and melt the ends together and put same vaseline all over it to make it seal better.
You'll also need 4 m3 screws and 4 washers to screw down the cover.
I was not able to test if its waterproof until yet, but i will update this thingi if necessary
didn't like the sealing and the cover of the original file, so i had to come up with my own idea,
For the sealing i take a peace of TPE filament and melt the ends together and put same vaseline all over it to make it seal better.
You'll also need 4 m3 screws and 4 washers to screw down the cover.
I was not able to test if its waterproof until yet, but i will update this thingi if necessary
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
