Floor Sconce

I created this candle floor sconce for table top war gaming. It's 7cm tall x 3.5cm wide. You'll need a paperclip, a thin piece of insulated wire, a 2032 coin cell battery & a 3mm flickering LED. Look for those on Amazon.com. Cut the negative lead of the LED to about 5mm long & solder the thin insulated wire to it. Straighten a small paperclip & solder that to the positive leg of the LED. Carefully feed the wires through the candle & super glue the LED into the candle. Then feed the wires through the sconce until they come out the middle of the base & superglue the candle onto the sconce. Cut the negative lead so it protrudes about 5mm out of the base. Strip the end of the wire & just fold it over. Carefully bend the paperclip 90°into the slot & then up 90° at the side. Trim it flush with the base. I filled the slot with superglue & added some baking soda to both instantly cure the superglue & insulate it from the negative wire. If your 2032 coin cell doesn't snap in the hole trim the e