Thingiverse
Floorstanding Tap Bracket
door digimatic
1
Downloads
1
Likes
0
Makes
Simple tap bracket to stop floor mounted taps for a freestanding Bath set from being so wobbly.
Looks great if printed in metal loaded filament, or just painted silver.
Obviously very specific dimensions are assumed for both the taps and the distance from the wall..As provided those dimensions are as follows.
Mounting point (on the taps) is 41mm diameter
Distance to wall is 180mm
Taps are 170mm apart (centres)
Screw holes (tap side) are sized at 2.8mm to allow a M3 machine thread screw to self thread. I'd recommend opening up either side (clamp or bracket) with a 3MM drill bit (depending on which side is easiest for you to install screws from)
Autocad Fusion source file included and unjoined so it should be simple to adjust as required.
Looks great if printed in metal loaded filament, or just painted silver.
Obviously very specific dimensions are assumed for both the taps and the distance from the wall..As provided those dimensions are as follows.
Mounting point (on the taps) is 41mm diameter
Distance to wall is 180mm
Taps are 170mm apart (centres)
Screw holes (tap side) are sized at 2.8mm to allow a M3 machine thread screw to self thread. I'd recommend opening up either side (clamp or bracket) with a 3MM drill bit (depending on which side is easiest for you to install screws from)
Autocad Fusion source file included and unjoined so it should be simple to adjust as required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!