Thingiverse

Floss 2 GoPro Session Mount (35 Degrees)

por Airmaxx23

53 Descargas

42 Likes

0 Makes

I searched around and couldn't find any GoPro Session mounts for the Hyperlite Floss 2 frame so I used my GoPro Session sleeve (found here: https://www.thingiverse.com/thing:2852274) and added the base. It has a 35 degree tilt and is mounted by using longer screws in the front standoffs and a short screw that goes through the rear of the case and top plate then held in place with a nut. I'm using a plastic (nylon) nut in hopes that it would break before the top plate in a bad crash. Please print this as it's shown in the render, no support are needed. This weighs 19 grams when printed with a 35% infill.

June 6, 2018: Added a second version with a slight cosmetic change.

floss Floss 2 GoPro guard hyperlite mount Protection protective session session 5 sleeve floss Floss 2 GoPro guard hyperlite mount Protection protective session session 5 sleeve

Fuente

Thingiverse

Lo que necesitas para imprimir: Principiante Baja confianza

¿Por qué?

sin soportes

Sin soportes Pieza única Tornillería requerida

Soportes 0/3

Ensamblaje 0/3

Ajustes 1/3

Tamaño de cama 0/3

Postproceso 1/3

Impresora

FDM / FFF

Formato de archivo

STL

Material

PLA, Nylon

Postprocesado

Tornillería

Software

Cura, PrusaSlicer o similar

Aún no hay valoraciones

Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias

Floss 2 GoPro Session Mount (35 Degrees)

Modelos similares

Añadir a colección