Thingiverse

FlosStyle Waffle Mount [beta]

par nerdCopter

3 Téléchargements

1 Likes

0 Makes

This is a CORRECTED METRIC PART -- FlosStyle v2 Mount
(The other one was not measured properly)

*Introducing the ugliest all-in-one mount you'll ever want!*
**The FlosStyle WAFFLE Mount** is a rear generic TPU multi-mount for the HyperLite FlosStyle v2.

You may mount your SMA/RPSMA VTX antenna, then zip-tie a VTX _and_ an RX _and_ zip-tie your RX antennae in your preferred vertical or horizontal "L" too.

The only probable issue is the lipo-strap may be tight against it, but hey it's TPU. I designed this with my VTX03 and R-XSR in mind.

Specs:
20mm tall.
Walls are 2.5mm thick.
SMA hole is 6.2mm diameter.
Interior wall has 2x2mm holes one connector-void and two 2x4.5mm slots.
Rear wall has 3x3mm holes.
Standoffs are for the 27mm apart Flosstyle.
Length of the interior wall is 33.3mm and should go almost all the way to the stack. Trim if necessary.
edit: i think probably wayyyy too thick now that i've learned some things.

All this was designed to maximize zip-t

eachine vtx03 flosstyle frsky Frsky XSR hyperlite flosstyle R-XSR rxsr r xsr sma mount vtx03 vtx mount XSR xsr mount eachine vtx03 flosstyle frsky Frsky XSR hyperlite flosstyle R-XSR rxsr r xsr sma mount vtx03 vtx mount XSR xsr mount

Source

Thingiverse

Ce qu'il faut pour imprimer: Débutant Confiance faible

Monobloc

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 0/3

Imprimante

FDM / FFF

Format de fichier